**NOTE** A. Only the monitors, which are not YES in theĬARB Readiness Status, need to be completed.ī. Specific criteria need to be met for each monitor.Įach monitor has a Pre-Test screen to assist in running the monitor.įor additional information, refer to the Chrysler Corporation Technical Training Workbook titled On Board Diagnostics: OBDII/EOBD, part num- ber 80. * NO, then the following procedure needs to be followed to run/complete all available monitors. * YES, then all monitors have been completed and this vehicle is ready to be I/M or Emission Tested. *The Emissions related DTC, will need to be repaired, then cleared. By clearing DTCs, the OBD Monitors will need to be run and completed to set the CARB Readiness Status.Ĩ. Return to Engine Select Function Menu andĭo all the CARB Readiness Status Locations read YES? *If an Emissions DTC is Present, the OBD II Monitors may not run and the CARB Readiness will not update. *Verify that No Emissions Related DTCs are Present. Watch for MIL lamp illumination during the bulb check. MIL lamp must have illuminated, if not, repair MIL lamp. Lecting Erase DTCs, the CARB Readiness and all additional OBDII information will be cleared. Not turn off the ignition. By turning the igni- tion key off, monitor enabling conditions will be lost. NVLD Monitor runs after key off.ī. By performing a Battery Disconnect, or Se. The following procedure has been established toĪssist Technicians in the field with enabling and running OBDII Monitors. The order listed in the following procedure is intended to allow the techni- cian to effectively complete each monitor and to set the CARB Readiness Status in the least time pos- sible.Ī. Once the monitor run process has begun, do
OBDII Monitor Run Process 2.0L/2.4L NGC Vehicles
0 kommentar(er)
